1/2" x 1/2" Barbed 90° Elbow Fitting

1/2" x 1/2" Barbed 90° Elbow Fitting

A polypropylene 90-degree barbed elbow for joining two sections of 1/2" hose or tubing at a right angle in your water line plumbing.

SPECIFICATIONS

• Dimensions: 2-1/2" x 1/2" x 2-1/2"
• Material: polypropylene, 100% corrosion resistant
• Meets ASTM D-2609 and ANSI/NSF 14 and 18
• Cold water use only; not compatible with compressed air or gases
• California residents: see Prop 65 WARNINGS

COMPATIBILITY

• Fits: 1/2" hose or tubing runs

INSTALLATION

A straightforward DIY connection; for the most secure joint, back up the barbed connection with a stainless steel hose clamp on each side.

PRO TIPS

• Cold water only, this fitting isn't rated for compressed air, gas, or hot supply lines, so don't use it anywhere near a boiler feed that sees elevated temperature.
• Always back up a barbed joint with a hose clamp rather than relying on the barb alone, especially on a pressurized water line.